Rm-materials-handling WIRE ROPE HOISTS Service Manual de usuario Pagina 106

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 130
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 105
R&M Materials Handling, Inc.
4501 Gateway Boulevard
Springfield, Ohio 45502
P.: (937) 328-5100
FAX: (937) 325-5319
106/130
R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.
6.2 Low headroom trolley, drum size φ 243 mm
Clearance between the wheel flange and the main girder flange (measure X) must be 3…5 mm. Ensure
that the clearance is equal on both ends of the trolley.
c_qztr01c
5
1
4
2
3
6
1. Locking washers
2. Fixing nuts
3. Plain washers
4. Adjusting nuts
5. Lifting mounts
6. Screw rods
Remove the temporary transport supports. Take the hoist out of the packing and move it to the
installation site. Lift the hoist using the lifting mounts (5).
! Do not unscrew the fixing nuts on the hoisting machinery side!
Lift the hoist onto the beam. Adjust the X measurement until there is a gap of approximately 3…5mm
between the flange of the travel wheels and the flange of the beam.
Check the wheels of the trolley are correctly aligned.
! Tighten the adjusting nuts (4) on both sides to the correct tightening torque. Refer to the
section “Recommended tightening torques”.
Vista de pagina 105
1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 129 130

Comentarios a estos manuales

Sin comentarios