Rm-materials-handling WIRE ROPE HOISTS Service Manual de usuario descargar pdf (Pagina 111)

R&M Materials Handling, Inc.

4501 Gateway Boulevard

Springfield, Ohio 45502

P.: (937) 328-5100

FAX: (937) 325-5319

111/130

R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.

! Tighten the nuts (2)/(6) and (3) to the correct tightening torque. Refer to the section

'Recommended tightening torques'.

c_nab2b

0,1-0,2 mm

6.5.2 Curved beam, when two trolleys

c_nab3a

2. Adjusting nuts for flange width

3. Trolley positioning nuts

4. Frame tube

5. Trolley side plate

• Remove the temporary transport supports. Take the hoist out of the packing and move it to the

installation site. Lift the hoist using the lifting lugs provided.

• Loosen the tightening nuts for flange width (2). Adjust the distance between the travel wheels (A) so

that it is slightly wider than the beam flange (B) for installation purposes by turning the screws (3). If

necessary, open also the screws (4).

• Lift the hoist onto the beam.

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 129 130

Sin comentarios

Rm-materials-handling WIRE ROPE HOISTS Service Manual de usuario Pagina 111