Rm-materials-handling WIRE ROPE HOISTS Service Manual de usuario descargar pdf (Pagina 79)

R&M Materials Handling, Inc.

4501 Gateway Boulevard

Springfield, Ohio 45502

P.: (937) 328-5100

FAX: (937) 325-5319

79/130

R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.

Re-assembly:

• Insert the rope into the rope anchorage

! Make sure the rope enters the anchorage in the correct direction. See section: “Rope

Anchorage, Service” for details

• Insert the wedge into the rope anchorage, making sure that a length of at least six times the rope

diameter protrudes from the anchorage.

• Pull the rope firmly into the rope anchorage, so that the shaft easily fits into the suspension hole.

• Place the rope anchorage into the overload device and insert the shaft with the washers.

! It is important that the rope anchorage is correctly mounted in the overload device. See the

below table for details:

Drum φ 243

Drum φ 303 and φ 355

Drum φ 406

Drum φ 608

• Assemble the rope clamps on the protruding end of the rope and insert the split-pin. Bend the split-pin

open.

# Insert NEW cotter pin, DO NOT reuse a removed cotter pin.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 129 130

Sin comentarios

Rm-materials-handling WIRE ROPE HOISTS Service Manual de usuario Pagina 79