Rm-materials-handling WIRE ROPE HOISTS Service Manual de usuario Pagina 33

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 130
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 32
R&M Materials Handling, Inc.
4501 Gateway Boulevard
Springfield, Ohio 45502
P.: (937) 328-5100
FAX: (937) 325-5319
33/130
R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.
5.9.1.2 Brake
c_brda1b
1. Fan cover
2. Fan
3. Brake
4. Inside of the brake
5. Brake disc
6. Friction plate
7. Anchor plate
8. Fixing screws
Lower the hook to the ground. Switch OFF the power supply to the hoist.
Remove the protective cover of the hoisting machinery.
Lock the rope drum with i.e. a wooden wedge, to prevent it from rotating.
! The weight of the rope may cause the drum to rotate when the gearbox is detached.
Remove the fan cover (1) and fan (2).
# Do not pull the fan by the fins! Place your fingers behind the fan and carefully pull the fan off the
shaft.
Remove the fixing screws for the brake.
Detach the brake (3).
Check the brake type on the rating plate fixed to the brake.
Measure the thickness of the brake disc (5).
Replace the brake disc if the thickness is less then the minimum thickness as according to the below
table.
Brake type and size Original thickness of
the brake disc
[mm]
Minimum thickness of
the brake disc
[mm]
Tightening torque for
brake fixing screws
[Nm] / [lbf.ft]
Tightening torque for
anchor plate screws
[Nm] / [lbf.ft]
NM39972NR# 7.00 6,6 5.0 / 3.7 5.0 / 3.7
NM38721NR# 8.00 7,6 9 / 6.6 2.5 / 1.8
NM38720NR# 8.00 7,6 9 / 6.6 2.5 / 1.8
NM38730NR# 10.40 10,1 9 / 6.6 2.5 / 1.8
NM38740NR# 11.15 10.4 22 / 16.2 5.0 / 3.7
Vista de pagina 32
1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 129 130

Comentarios a estos manuales

Sin comentarios