Rm-materials-handling WIRE ROPE HOISTS Service Manual de usuario descargar pdf (Pagina 76)

R&M Materials Handling, Inc.

4501 Gateway Boulevard

Springfield, Ohio 45502

P.: (937) 328-5100

FAX: (937) 325-5319

76/130

R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.

5.27 Sheave support and rope anchorage support

5.27.1 Service (R2 and R4 reevings)

L. Locking plate

W Locking washer

OW Old type washer

L+S Locking plate + locking screw

L. Locking plate

OL. Old type locking plate

NL. New type locking plate

W. Locking washer

L+S Locking plate + locking screw

• Check that the support shaft and the rope anchorage plate (or overload device) are correctly in their

slots.

• Check that the locking part is in the groove of the shaft in cases which there is no other block against

the shaft's axial movement.

# Replace locking washer (OW) or locking plate (OL) with the shaped locking plate (NL) if possible.

Or replace locking washer (W) with the locking plate (L) if possible.

• Check that fixing screws are tight.

• Check that the sheave block and the rope anchorage can freely tilt with rope.

• Lubricate the load carrying surfaces in the ends of the shaft and the rope anchorage plate with a

small amount of grease.

5.28 Rope anchorage

The free end of the rope is fixed in a suspended rope anchorage. The rope clamps ensure that the rope

can not accidentally slip through the rope anchorage.

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 129 130

Sin comentarios

Rm-materials-handling WIRE ROPE HOISTS Service Manual de usuario Pagina 76