Rm-materials-handling WIRE ROPE HOISTS Service Manual de usuario descargar pdf (Pagina 78)

R&M Materials Handling, Inc.

4501 Gateway Boulevard

Springfield, Ohio 45502

P.: (937) 328-5100

FAX: (937) 325-5319

78/130

R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.

13-14 25 194 65 23 M10 15

15-16 30 220 65 25 M12 18

• Check that the rope clamp-nuts are tight.

• Ensure that the rope has not slipped in the rope anchorage by comparing the measures with the

stated measures in the table.

• Make sure the rope end protrudes from the rope anchorage as specified on table.

• Check the condition of the rope at point “A”.

• Ensure that the rope is assembled inside the rope anchorage correctly.

5.28.2 Assembly

roan01

d000491c

1. Rope

2. Rope anchorage

3. Wedge

4. Rope clamp

5. Split-pin

6. Washer

7. Shaft

Disassembly:

• Lower the hook onto a stable platform. Pull some more rope off the drum with a gloved hand.

• Switch OFF the power supply to the hoist.

• Remove the split-pin (5).

• Remove the washers (6) and the shaft (7) while holding the rope anchorage (2).

• Slide the rope anchorage out of the overload device.

• Remove the rope clamps (4).

• Tap the wedge (3) out of the rope anchorage and remove the rope (1).

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 129 130

Sin comentarios

Rm-materials-handling WIRE ROPE HOISTS Service Manual de usuario Pagina 78