Rm-materials-handling WIRE ROPE HOISTS Service Manual de usuario descargar pdf (Pagina 52)

R&M Materials Handling, Inc.

4501 Gateway Boulevard

Springfield, Ohio 45502

P.: (937) 328-5100

FAX: (937) 325-5319

52/130

R&M Materials Handling, Inc. reserves the right to alter or amend the above information without notice.

5.19.1 Service

5.19.1.1 Traveling motor

• Check that the traveling motor operates properly when loaded.

• Check for any excessive noise, vibration and/or heat.

• Clean the cooling-ribs surface when needed.

5.19.1.2 Traveling gearbox

• Check the gearbox visually for leakage.

• In case the gearbox shows signs of excessive leakage, find the reason for this and replace the worn

part, or the complete gearbox.

• Check the breather-plug (if applicable) breaths freely and clean if needed.

• Check for any excessive vibration and/or noise.

# If the factory-installed grease is topped up with a different lubricant, ensure that the lubricant is

compatible. Refer to the section “Lubricants” for further instructions.

5.19.1.3 Traveling brake

• Remove the end-cap of the motor.

• Check the air gap of the brake.

! If the air gap is greater than 0,2…0,3 mm, the brake disc may be worn out. Check the

thickness of the brake disc.

• Adjust the air gap when needed.

• Remove dust and dirt from the brake.

• Close the end-cap and check the proper functioning.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 129 130

Sin comentarios

Rm-materials-handling WIRE ROPE HOISTS Service Manual de usuario Pagina 52